Sniper Configuration
Auto Mode
Please indicate the address of the smart contract you want to snipe.
Select the wallet from which you want to execute the snipe. If you wish to snipe from multiple wallets without selecting all of them, you will need to create a snipe order for each desired wallet.
Below, specify the maximum amount of ETH you want to allocate for the snipe or the maximum quantity of tokens desired. If you only specify an ETH quantity, the sniper will purchase the maximum possible tokens for that amount. If you only specify a maximum token quantity, the sniper will use all available ETH to purchase the desired quantity of tokens.
Manual mode
The manual mode allows you to fine-tune snipe parameters to adapt to different launch scenarios.
LP SNIPE: If this function is enabled, the sniper will be triggered as soon as liquidity is added to the token's LP (Liquidity Pool) that you want to snipe.
FIRST OR FAIL: If this function is enabled, the sniper will abandon purchase attempts if it fails to buy in the first block after the trading opens.
CONTRACT FUNCTION SNIPE: If the contract you want to snipe has a launch function (trading opening, launch, etc.), you can enter the function code by researching in the smart contract (example below). In this example, the code to enter in the "Contract function snipe" bar is as follows: 0x6b0ec5b6.
BLOCK DELAY: The block delay (or dead blocks) is used if you have information that the contract will be launched with trading blocks delayed to trap snipers. Depending on the block delay you specify, the snipe will be triggered once the specified number of blocks has elapsed after the token launch.
Last updated